( full specifications are in the manual for the device )
1. Controller of physical and chemical parameters of gas FHP (hereinafter referred to as Controller FHP) is intended for
ensuring the interaction of the gas flow metering complex with the chromatograph, moisture analyzer and control room
service and is designed to work in automatic process control systems, telemechanics complexes,
complexes of commercial accounting of gas in various industries.
2. FHP controller provides collection, processing, accumulation and transmission of information from the gas chromatograph
into the calculator's memory for subsequent accounting of gas, taking into account its composition. The gas composition is updated
before the start of each contract period.
The number of surveys per day and the time of transmission of calculation results are determined by the user independently.
3. The FHP controller is not a measuring instrument.
4. Operation of the FHP controller is allowed at ambient temperature from minus 40 °С to plus 70 °С.
5. The FHP controller performs the following functions:
- continuous interrogation of the chromatograph and moisture analyzer;
- calculation of density and specific heat of combustion, according to the selected standard conditions (if necessary);
- archiving of the received data in the non-volatile memory of the controller;
- formation of an archive based on the received consumption data for the past day, current daily and current hourly values;
- maintaining an archive of emergency situations;
- control of the received data for compliance with the established ranges with the formation of appropriate diagnostic messages.
- recording the physical and chemical parameters of the gas in the gas flow calculator, according to the selected regulation;
- transfer of historical data on consumption and calorific value upon request of data acquisition systems and / or automatic transfer
to the selected server;
- relaying requests to gas flow calculators.
- etc . . .
PS. - Attention! - If necessary, the user can independently
Configure the FHP Controller in accordance with the type of chromatograph used in one of the programs
(see below - "Software").
1. The FHP controller provides data exchange at speeds from 9600 to 57600 bps (depending on the selected one interface port).
2. It has a galvanic solution between RS232, RS485, PLI interfaces.
3. The power supply voltage of the FHP controller is provided by the nominal voltage of direct current - 12 V (permissible - from 10 to 24 V);
consumption current:
- minimum not less than 50 mA;
- maximum, taking into account the GSM modem, not more than 1580 mA;
- power consumption - no more than 2.2 W.
4. The degree of protection of the body of the FHP Controller from environmental influences is IP30 in accordance with GOST 14254.
5. Overall dimensions of the FHP Controller do not exceed 160 x 100 x 60 mm.
6. The mass of the controller does not exceed - 0.5 kg.
7. The service life of the FHP Controller is 12 years.
1. The FHP controller is made in a plastic case with brackets for mounting on a DIN rail In this case,
the controller must be protected from the direct action of precipitation.
2. The company provides warranty service for the FHP controller within 24 months and after-sales service
throughout the service life.
List of configurator programs in accordance with the equipment used
(chromatograph and moisture meter)
as part of FLOUTEC-TM complexes
FHP_controller – FHP Controller configuration program